CLEAT FOR ALLEN 470 SPI

Choke Holt Allen for the pump system of the halyard, spinnaker 470. Choke to use for the hoisted the halyard, spinnaker dinghies with the system of "pumping".

This system allows you to hoist the spinnaker on the part of the helmsman with one hand and very quickly. Made of anodized aluminum and stainless steel AISI 316.

Features

The maximum diameter of the top: 1,5

- 4mm Length: 40mm

Height: 33.5 mm

Distance between mounting holes: 18mm

Diameter of fixing holes: 5mm Weight: 37g

A unique, hard-to-find, pivoting cleat that allows the line to run freely until it is pulled out of alignment. Frequently used used for spinnaker halyard pump-up systems.

The halyard exits the mast, goes through a cam cleat and usually a fairlead. Then there is some space before the halyard runs through the pump cleat.

On the line in this space there is to trap the handle on a block, which you hold to pump. The tail of the halyard then continues through a fairlead or cheek block and is taken up by shock cord.

As you pump the handle, the pump-cleat goes out of alignment, holding the tail and causing the halyard to take up through the cam cleat.

As you lower the handle, the pump cleat aligns again allowing the shock cord to take up the tail through the pump cleat, readying the system for another pump if needed.